KLR650 Backrest Instructions








Your hardware kit includes the following:

1. one 4 mm x 9 inch hex wrench

2. six - 6 mm bolts (Short)

3. two - 6 mm nylon locking nuts

4. four - 6 mm bolts (Long)

  1. 5. four - Washers

  2. 6. six 4 - Aluminum Spacers

7. two - Quick Release Pins









Step 1.

a. Remove the four existing perimeter bolts on

    your plastic cargo rack.

b. Leave the two bolts directly behind the tool

    carrier

c. Discard the factory bolts

d. Leave the factory pressed in aluminum spacers

    on the factory cargo rack.

e. Install 4 new spacers provided












Step 2.

a. Install new aluminum Cargo Rack

b. Align holes

c. Install 4- Long 6 mm bolt and Washers

d. Thread bolts but do not tighten












Step 3.

a. Install sliders to the back rest plate.

b. Notice sliders are mounted inside the angle back

    plate

c. Use 2- 6 mm short bolts and 2 - nylon locking

    nuts

d. Tighten bolts to allow the back rest to tilt forward

    and back.












Step 4.

a. Install backrest and slider into place
















Step 5.

a. Tighten slider using 4 - 6 mm bolts

b. WARNING...DO NOT OVER TIGHTEN

ALUMINUM THREADS!

c. For solo rider adjust cargo rack to the forward

position, using less slider.












Step 6.

a. Install quick release pins. Start at the middle

setting. (this is the most popular setting)

b. At this point its time to fit the back rest to your

desired comfort.

  1. c.Tighten cargo rack bolts

d. ENJOY!






We hope you enjoy your new backrest by klrdash. If you have any questions or

comments please feel free to contact us at klrdash@hotmail.com

 

KLR650 BACKREST VIDEO